Installation

METER / GAUGE / DISPLAY: COMBINATION METER: INSTALLATION

1. INSTALL COMBINATION METER ASSEMBLY

(a) Connect the connector and temporarily install the combination meter assembly.

NOTICE:
When installing the combination meter assembly, do not damage the upper instrument panel sub-assembly and combination meter assembly.

(b) Install the combination meter assembly with the 4 screws.

2. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL

(a) Engage the 11 clips and install the No. 1 instrument cluster finish panel.

(b) Engage the 2 claws and 4 clips and install the instrument cluster finish panel.

3. INSTALL INSTRUMENT PANEL FINISH PANEL Installation

4. INSTALL INSTRUMENT SIDE PANEL LH Installation

5. INSTALL FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY Installation

6. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

7. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation

8. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

9. INSTALL STEERING WHEEL ASSEMBLY Installation

10. INSTALL STEERING PAD Installation

11. INSTALL LOWER NO. 3 STEERING WHEEL COVER Installation

12. INSTALL LOWER NO. 2 STEERING WHEEL COVER Installation

13. INSPECT STEERING WHEEL CENTER POINT

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

15. INSPECT STEERING PAD Steering Pad

16. INSPECT SRS WARNING LIGHT

Diagnosis System