Rear Axle Hub

AXLE AND DIFFERENTIAL: REAR AXLE HUB: ON-VEHICLE INSPECTION

1. INSPECT REAR AXLE HUB BEARING LOOSENESS

(a) Using a dial indicator, check for looseness near the center of the axle hub.





Maximum:

0.05 mm (0.0020 in.)

If looseness exceeds the maximum, replace the axle hub assembly.

NOTICE:
Ensure that the dial indicator is set at right angles to the measurement surface.

2. INSPECT REAR AXLE HUB RUNOUT

(a) Using a dial indicator, check for runout in the surface of the axle hub outside the hub bolt.





Maximum:

0.07 mm (0.0027 in.)

If runout exceeds the maximum, replace the axle hub assembly.

NOTICE:
Ensure that the dial indicator is set at right angles to the measurement surface.