Installation

1AR-FE ENGINE CONTROL: CRANKSHAFT POSITION SENSOR: INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR

(a) Apply a light coat of engine oil to the O-ring of the sensor.

NOTICE:
Make sure that the O-ring is not cracked or does not jump out of position during installation.

(b) Apply adhesive to 2 or 3 threads of the bolt.





Text in Illustration





Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.

(c) Install the sensor with the bolt.

Torque : 6.5 Nm (66 kgf-cm, 58 in-lbf)

(d) Connect the crankshaft position sensor connector.

2. INSPECT FOR OIL LEAK

(a) Start the engine and check that there are no oil leaks.