Removal

TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING VALVE: REMOVAL

1. REMOVE FRONT WHEEL

2. REMOVE REAR WHEEL

3. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER

(a) Remove the cap and valve core, and release the air from the tire.

(b) After ensuring that a sufficient amount of air has been released, remove the nut and washer that are used to secure the tire pressure warning valve and transmitter. Drop the tire pressure warning valve and transmitter inside the tire.

HINT
Keep the removed cap, valve core, nut, and washer.

(c) After dropping the tire pressure warning valve and transmitter into the tire, disengage the bead using the shoe of the tire remover.





Text in Illustration





NOTICE:
* Be careful not to damage the tire pressure warning valve and transmitter due to interference between the valve and the tire bead.
* Set the tire remover shoe as shown in the illustration.

Width (A):

10 to 20 mm (0.394 to 0.787 in.)

(d) Remove the bead on the upper side in the usual way.

(e) Take out the tire pressure warning valve and transmitter from the tire and remove the bead on the lower side in the usual way.

NOTICE:
If replacing the tire pressure warning valve and transmitter, make sure that a new grommet, washer, and nut are used.