Multi-media Interface ECU Communication Error

AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: Multi-media Interface ECU Communication Error
- Multi-media Interface ECU Communication Error

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. IDENTIFY COMPONENT SHOWN BY SUB-CODE

(a) Enter diagnostic mode.





(b) Press preset switch "channel 2" to change to "Detailed Information Mode".

(c) Identify the component shown by the sub-code.

HINT
* "190 (radio receiver assembly)" is the component shown by the sub-code in the example shown in the illustration.
* For details of the DTC display, refer to DTC Check/Clear Reading and Clearing Diagnostic Trouble Codes.

NEXT -- Continue to next step.

2. CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE

(a) Inspect the power source circuit of the component shown by the sub-code.

If the power source circuit is operating normally, proceed to the next step.

HINT
The satellite radio tuner is built into the radio receiver assembly. If there is a problem between the satellite radio tuner and radio receiver, replace the radio receiver assembly.

Component Table





*1: w/ Stereo Component Amplifier Assembly

*2: w/ Rear Seat Entertainment System

NEXT -- Continue to next step.

3. INSPECT RADIO RECEIVER ASSEMBLY

(a) Disconnect the D133* and D60 radio receiver assembly connectors.





*: w/ Stereo Component Amplifier Assembly

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





*: w/ Stereo Component Amplifier Assembly

Text in Illustration





NG -- REPLACE RADIO RECEIVER ASSEMBLY Removal
OK -- Continue to next step.

4. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT SHOWN BY SUB-CODE)

HINT
* Start the check from the circuit that is near the component shown by the sub-code first.
* For details of the connectors, refer to Terminals of ECU Pinout Values and Diagnostic Parameters.

(a) Referring to the wiring diagram, check the AVC-LAN circuit between the multi-media interface ECU and component shown by the sub-code.

(1) Disconnect all connectors between the multi-media interface ECU and component shown by the sub-code.

(2) Check for an open or short in the AVC-LAN circuit between the multi-media interface ECU and component shown by the sub-code.

OK:

There is no open or short circuit.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

5. REPLACE COMPONENT SHOWN BY SUB-CODE

(a) Replace the component shown by the sub-code with a known good one and check if the same problem occurs again.

OK:

Malfunction disappears.

NG -- REPLACE MULTI-MEDIA INTERFACE ECU Removal

OK -- END