Installation

2GR-FE ENGINE CONTROL: CRANKSHAFT POSITION SENSOR: INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR

(a) Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.





Text in Illustration





NOTICE:
* When reusing the sensor, inspect the O-ring.
* If the O-ring has scratches or cuts, replace the crankshaft position sensor.

(b) Install the crank position sensor with the bolt.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(c) Connect the crank position sensor connector.

2. INSTALL W/PULLEY COMPRESSOR ASSEMBLY

Installation