Canada - Body - Sliding Roof Side Garnish Is Loose

Bulletin
T-TCI-3678

Issue Date
December 12, 2011

Market
Canada

Title
SLIDING ROOF SIDE GARNISH LOOSE

Service Category
Vehicle Exterior

Section
Sliding Roof/Convertible

Market
Canada






APPLICABILITY:

INTRODUCTION:

Some 2011 Sienna vehicles may exhibit a condition where the side garnishes for the front sliding roof may become loose or damaged during sliding roof operation. A new garnish has been designed to address this condition.

PRODUCTION CHANGE INFORMATION:







This TSB applies to vehicles produced BEFORE the Production Change Effective VIN shown.






WARRANTY INFORMATION:






PARTS INFORMATION:

REPAIR PROCEDURE:

NOTE
The entire sliding roof housing does NOT need to be replaced. Only the garnish and the plastic holder should be changed.







1. Remove the LH & RH garnishes.
2. Unseat the bottom portion of the garnish and separate.

HINT
Use same procedure for both sides.

3. Open the sliding roof glass.
4. Remove the screw from the front of the garnish holder.
5. Slide the garnish holder off the track end.
6. Slide the NEW garnish holder onto the track and align it with the existing screw hole in track.







7. Replace the screw to the front of the holder.
8. Install the new garnishes.







9. Check to make sure the slot in the new garnish is correctly seated into the new holder with hook.
10. Operate the sliding roof to confirm proper operation.

NOTE:
Issue of this Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.