Disassembly: LH Side

CAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.





1. Place the seatback in the upright position prior to disassembly. If seatback will not lock into place, some steps will require another person to hold the seatback upright in order to properly disassemble.





2. Remove the rear No. 2 seat cover bezel. Figure 1.

A. Remove the 4 screws.

B. Disengage the 4 guides and remove the 4 rear No. 2 seat cover bezels.





3. Using a plastic pry tool, disengage the 3 claws and remove the rear seatback lock striker cover.

4. Remove the third seat handle.





A. Remove the 2 screws.

B. Disengage the 3 guides and separate the third seat handle.





C. Disconnect the 4 cable clamps and remove the third seat handle.





5. Remove the rear seatback lock control bezel.

A. Remove the screw.

B. Disengage the guide and remove the rear seatback lock control bezel.





6. Remove the rear No. 2 seat reclining cover LH.

A. Disengage the 8 clips and remove the rear seatback board cover LH.





B. Remove the 2 screws.

C. Disengage the 2 guides and remove the rear No. 2 seat reclining cover LH.





7. Remove the rear No. 2 seat reclining cover RH.

A. Remove the 2 screws.

B. Disengage the 2 guides and remove the rear No. 2 seat reclining cover RH.





8. Remove the bolt and the left hand rear No. 2 seat center lap belt assembly.

9. Remove the rear center seat headrest assembly.

10. Remove the No. 2 seat headrest assembly.





A. Remove the 10 hog rings and 2 clips.





B. Remove the 5 hog rings.





C. Remove the clip and pass the No. 2 seat reclining release handle sub-assembly through the No. 2 seatback cover with pad LH.

D. Using a screwdriver with its tip wrapped in protective tape, release the lock inside the headrest support and remove the No. 2 seat headrest assembly.

11. Remove the rear No. 2 seat headrest support assembly.

Disengage the 8 claws and remove the 4 rear No. 2 seat headrest support assemblies.





12. Remove the No. 2 seatback cover with pad LH.

13. Remove the No. 2 seatback frame sub-assembly LH.





A. Disconnect the 3 cable clamps and separate Figure 16. the 2 reclining remote control cable assemblies.

B. Remove the 4 bolts and No. 2 seatback frame sub-assembly LH.

14. Remove the No. 2 seat reclining release handle sub-assembly.





Remove the nut, No. 2 seat reclining release handle sub-assembly, and reclining bolt lock plate.





15. Remove the nut and No. 1 reclining release handle sub-assembly.