Removal

AXLE: FRONT AXLE HUB (for 2WD): REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT WHEEL

3. SEPARATE SKID CONTROL SENSOR WIRE





(a) Remove the speed sensor connector.

(b) Remove the 2 bolts, and separate the skid control sensor wire.

4. REMOVE FRONT SPEED SENSOR

(a) Remove the bolt, and then remove the front speed sensor.

5. SEPARATE FRONT FLEXIBLE HOSE





(a) Remove the bolt, and separate the front flexible hose.

6. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY





(a) Remove the union bolt and gasket from the disc brake cylinder and then disconnect the flexible hose.

(b) Remove the 2 bolts, and then remove the brake caliper.





7. REMOVE FRONT DISC

8. SEPARATE TIE ROD END SUB-ASSEMBLY

(a) Remove the cotter pin and nut.

(b) Using SST, separate the tie rod end from the steering knuckle arm.





SST : 09610-20012

9. SEPARATE FRONT SUSPENSION LOWER ARM





(a) Remove the 2 bolts, and separate the front lower ball joint attachment from the front axle.

10. SEPARATE FRONT SUSPENSION UPPER ARM





(a) Remove the clip and nut.

(b) Using SST, separate the upper ball joint from the steering knuckle.

SST : 09628-62011

11. REMOVE FRONT AXLE HUB