Installation

A340F AUTOMATIC TRANSMISSION: PARK / NEUTRAL POSITION SWITCH: INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Install the park/neutral position switch onto the manual valve lever shaft and provisionally tighten the adjusting bolt.

(b) Install the grommet, a lock washer and the nut.

Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)

(c) Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.





Text in Illustration





(d) Align the neutral basic line with the switch groove and tighten the adjusting bolt.





Text in Illustration





Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)

(e) Bend the tabs of the lock washer.

HINT
Bend at least 2 of the lock washer tabs.

2. CONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR

3. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY A340F Automatic Transmission

4. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY A340F Automatic Transmission

5. ADJUST SHIFT LEVER POSITION A340F Automatic Transmission

6. INSPECT SHIFT LEVER POSITION A340F Automatic Transmission