Operation CHARM: Car repair manuals for everyone.

Reassembly





AXLE: FRONT AXLE HUB (for 2WD): REASSEMBLY

1. INSTALL FRONT AXLE HUB INNER BEARING





(a) Using SST and a press, press a new bearing into the steering knuckle.

SST : 09527-17011

SST : 09608-10010

(b) Using snap ring pliers, install a new snap ring.

2. INSTALL FRONT AXLE HUB OIL SEAL





(a) Using SST and a plastic-faced hammer, tap in a new oil seal.

SST : 09223-15020

SST : 09527-17011

(b) Coat MP grease to the oil seal lip.

3. INSTALL STEERING KNUCKLE





(a) Install the dust cover onto the steering knuckle with the 3 bolts.

Torque : 8.3 Nm (85 kgf-cm, 73 in-lbf)

(b) Using SST and a press, press in the axle hub to the steering knuckle.

SST : 09710-30050

4. INSTALL FRONT AXLE HUB NUT





(a) Attach the 3 bolts onto the hub bolt in the position shown in the illustration, and screw them into the flange, then fix them in a vice.

(b) Install the spacer.

(c) Using a socket wrench (36 mm), install a new lock nut onto the axle hub.

Torque : 199 Nm (2,029 kgf-cm, 147 ft-lbf)

(d) Using a chisel and hammer, stake the lock nut.

5. INSTALL KNUCKLE GREASE RETAINER CAP





(a) Using a brass bar and hammer, install the knuckle grease retainer cap.

NOTICE:
Do not damage the knuckle grease retainer cap.