Entire Combination Meter Does Not Operate

METER: METER / GAUGE SYSTEM: Entire Combination Meter does not Operate
- Entire Combination Meter does not Operate

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. CHECK FUSE

(a) Remove the ECU-B fuse, AM2 fuse and short pin from the engine room R/B.

(b) Remove the GAUGE fuse from the driver side J/B.

(c) Measure the resistance.

Standard Resistance:

Below 1 Ohms

(d) Reinstall the fuses and short pin.

NG -- INSPECT FOR SHORT CIRCUIT IN HARNESS AND ALL COMPONENTS CONNECTED TO FUSE
OK -- Continue to next step.

2. INSPECT COMBINATION METER ASSEMBLY

(a) Disconnect the C9 combination meter connector.

(b) Measure the resistance.

Standard Resistance:

(d) Reconnect the combination meter connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE COMBINATION METER ASSEMBLY