Installation

2TR-FE EMISSION CONTROL: HEATED OXYGEN SENSOR: INSTALLATION

1. INSTALL HEATED OXYGEN SENSOR





(a) Using SST, install the heated oxygen sensor.

SST : 09224-00010

Torque : 44 Nm (449 kgf-cm, 33 ft-lbf)

Torque : 40 Nm (408 kgf-cm, 30 ft-lbf) with SST

NOTICE:
Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).

(b) Connect the wire harness clamp. (4WD DRIVE TYPE)





(c) Connect the oxygen sensor connector.

2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 3.9 Nm (40 kgf-cm, 35 in-lbf)

3. CHECK FOR EXHAUST GAS LEAKAGE