Installation

CRUISE CONTROL: CLUTCH SWITCH: INSTALLATION

1. INSTALL CLUTCH SWITCH ASSEMBLY

(a) Install the clutch switch assembly and tighten the nut.





(b) Connect the connector.

2. INSTALL DRIVER SIDE JUNCTION BLOCK

(a) Install the driver side junction block assembly with the 2 nuts.





Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(b) Install the bracket with the 2 bolts.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

3. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Installation

4. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY Reassembly

5. INSTALL INSTRUMENT PANEL HOLE COVER (for Lever Type Parking Brake) Installation

6. INSTALL INSTRUMENT PANEL UNDER TRAY (for Pedal Type Parking Brake) Installation

7. INSTALL COWL SIDE TRIM BOARD LH (for Regular Cab) Installation

8. INSTALL COWL SIDE TRIM BOARD LH (for Access Cab) Installation

9. INSTALL COWL SIDE TRIM BOARD LH (for Double Cab) Removal

10. INSTALL FRONT DOOR SCUFF PLATE LH (for Regular Cab) Installation

11. INSTALL FRONT DOOR SCUFF PLATE LH (for Access Cab) Installation

12. INSTALL FRONT DOOR SCUFF PLATE LH (for Double Cab) Installation

13. INSTALL FRONT FLOOR FOOTREST Installation

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 3.9 Nm (40 kgf-cm, 35 in-lbf)