Installation

1GR-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION

1. INSPECT V-RIBBED BELT TENSIONER ASSEMBLY

(a) Check that nothing gets caught in the tensioner by turning it clockwise and counterclockwise.

If a malfunction exists, replace the tensioner.

2. INSTALL FAN & GENERATOR V BELT





(a) While turning the belt tensioner counterclockwise, align with its holes, and then insert a bar of 6 mm (0.24 in.) into the holes to fix the belt tensioner.

(b) Install the V-ribbed belt.

(c) While turning the belt tensioner counterclockwise, remove the bar.

(d) If it is hard to install the V-ribbed belt, perform the following procedure.





(1) Put the V-ribbed belt on all parts except the P/S pump, as shown in the illustration.

(2) While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the P/S pump.

3. INSTALL NO.1 ENGINE UNDER COVER SUB-ASSEMBLY (for Pre Runner and 4WD Type)

(a) Install the engine under cover with the 4 bolts.

Torque : 29 Nm (296 kgf-cm, 21 ft-lbf)