Installation

A750E AUTOMATIC TRANSMISSION: PARK / NEUTRAL POSITION SWITCH: INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY





(a) Install the park/neutral position switch onto the manual valve lever shaft and provisionally tighten the adjusting bolt.

(b) Install the grommet, a new lock washer and the nut.





Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)

(c) Install the manual valve lever shaft onto the groove and turn it 2 notches counterclockwise to the neutral position.

(d) Align the neutral basic line with the switch groove and tighten the adjusting bolt.

Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)

(e) Bend the tabs of the lock washer.

HINT
Bend at least 2 of the lock washer tabs.

2. CONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 3.9 Nm (40 kgf-cm, 35 in-lbf)

4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY A750E Automatic Transmission

5. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY A750E Automatic Transmission

6. ADJUST SHIFT LEVER POSITION A750E Automatic Transmission

7. INSPECT SHIFT LEVER POSITION A750E Automatic Transmission