Hydraulic Test

A750E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION SYSTEM: HYDRAULIC TEST

1. PERFORM HYDRAULIC TEST





(a) Measure the line pressure.

CAUTION:
The line pressure test should always be carried out in pairs. One technician should observe the condition of the wheels or wheel stoppers from outside the vehicle while the other is doing the test.

NOTICE:
* Perform the test at the normal operating ATF (Automatic Transmission Fluid) temperature of 50° to 80°C (122° to 176°F).
* Be careful to prevent SST hose from interfering with the exhaust pipe.
* This check must be conducted after checking and adjusting the engine.
* Perform with the A/C OFF.
* Do not conduct stall tests for longer than 5 seconds continuously.

(1) Warm up the ATF.

(2) Lift the vehicle up.

(3) Remove the test plug on the transmission case center right side and connect SST.

SST : 09992-00095

09992-00151

09992-00271

(4) Fully apply the parking brake and chock the 4 wheels.

(5) Start the engine and check the idling speed.

(6) Keep your left foot pressed firmly on the brake pedal and move the shift lever to D.

(7) Measure the line pressure while the engine is idling.

(8) Fully depress the accelerator pedal with your right foot. Quickly read the highest line pressure when the engine speed reaches the stall speed.

(9) Perform the line pressure test again with the shift lever in R.

Specified Line Pressure:





Evaluation