ABS (Antilock Brake System)

BRAKE CONTROL: ANTI-LOCK BRAKE SYSTEM: DIAGNOSTIC TROUBLE CODE CHART

NOTICE:
When removing any parts, turn the ignition switch off.

HINT
* Using SST 09843-18040, connect terminal TC and CG of the DLC3.
* If no abnormality is found when inspecting parts, inspect the ECU and ground points for poor contact.
* If a DTC is displayed during the DTC check, check the circuit for the DTC listed in the table below. For details of each DTC, refer to the page indicated.
* When 2 or more DTCs are recorded and the problem cannot be identified, perform circuit inspection of the other DTCs.

ABS System













(*1): Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed.

1. Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.

2. Clear the DTC.

ABS System Test Mode