Operation CHARM: Car repair manuals for everyone.

A750E Automatic Transmission System





A750E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION SYSTEM: P0985,P0986: Shift Solenoid "E" Control Circuit Low (Shift Solenoid Valve SR)
P0986 - Shift Solenoid "E" Control Circuit High (Shift Solenoid Valve SR)

DESCRIPTION

These DTCs indicate an open or short in the shift solenoid valve SR circuit. When there is an open or short circuit in any shift solenoid valve circuits, the ECM detects the problem, illuminates the MIL, and stores the DTC. When the shift solenoid valve SR is on, if the resistance is 8 Ohms or less, the ECM determines that there is a short malfunction in the shift solenoid valve SR circuit. When the shift solenoid valve SR is off, if the resistance is 100 kOhms or more, the ECM determines that the shift solenoid valve SR circuit is open Fail-Safe Chart.





MONITOR DESCRIPTION

These DTCs indicate an open or short in the shift solenoid valve SR circuit. When there is an open or short circuit in any shift solenoid valve circuits, the ECM detects the problem, illuminates the MIL and stores the DTC. When the shift solenoid valve SR is on, if the resistance is 8 Ohms or less, the ECM determines that there is a short malfunction in the shift solenoid valve SR circuit.

When the shift solenoid valve SR is off, if the resistance is 100 kOhms or more, the ECM determines that the shift solenoid valve SR circuit is open Fail-Safe Chart.

MONITOR STRATEGY





TYPICAL ENABLING CONDITIONS

All





P0985: Range Check (Low Resistance)





P0986: Range Check (High Resistance)





TYPICAL MALFUNCTION THRESHOLDS

P0985: Range Check (Low Resistance)





P0986: Range Check (High Resistance)





COMPONENT OPERATING RANGE





WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
Perform the universal trip to clear permanent DTCs DTC Check / Clear.

HINT
The shift solenoid valve SR is turned on/off normally when the shift lever is in D:





PROCEDURE

1. INSPECT TRANSMISSION WIRE (SR)

(a) Disconnect the transmission wire connector from the transmission.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- INSPECT SHIFT SOLENOID VALVE SR
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM)

(a) Connect the transmission wire connector to the transmission.





(b) Disconnect the connector from the ECM.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE ECM Removal

3. INSPECT SHIFT SOLENOID VALVE SR

(a) Remove the shift solenoid valve SR.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





(c) Connect the battery's positive (+) lead to the terminal of the solenoid valve connector, and the negative (-) lead to the solenoid body. Then check that the valve moves and makes an operating noise.

OK:

The solenoid makes an operating sound.

NG -- REPLACE SHIFT SOLENOID VALVE SR

OK -- REPAIR OR REPLACE TRANSMISSION WIRE Removal