Installation

1GR-FE ENGINE CONTROL SYSTEM: VVT SENSOR: INSTALLATION

1. INSTALL VVT SENSOR

(a) LH bank side VVT sensor:

(1) Apply a light coat of engine oil to the O-ring of the VVT sensor.

(2) Install the VVT sensor with the bolt.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(3) Connect the VVT sensor connector.

(4) Connect the water by-pass hoses No. 4 and No. 5.

(b) RH bank side VVT sensor:

(1) Apply a light coat of engine oil to the O-ring of the VVT sensor.

(2) Install the VVT sensor with the bolt.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(3) Connect the VVT sensor connector.

2. INSTALL AIR CLEANER ASSEMBLY Installation

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 3.9 Nm (40 kgf-cm, 35 in-lbf)

4. ADD ENGINE COOLANT Service and Repair

5. CHECK FOR ENGINE COOLANT LEAKAGE Service and Repair

6. INSTALL V-BANK COVER

(a) Install the V-bank cover with the 2 nuts.

Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)