Programming and Relearning
SEAT BELT: SEAT BELT WARNING SYSTEM: CUSTOMIZE PARAMETERS
1. COMBINATION METER ASSEMBLY
NOTICE:
* Be sure to record the current value before customizing.
HINT
The following item can be customized without using a Techstream.
2. SEAT BELT BUZZER ON/OFF SETTING
The seat belt buzzer ON/OFF setting, which is a setting of the buzzer function of the combination meter, can disable the driver and front passenger side seat belt buzzers.
NOTICE:
* When the buzzer OFF setting is selected, the buzzer activation while the vehicle is being driven is cancelled. However, the buzzer activation when the ignition switch is turned to ON cannot be cancelled.
* These buzzers should be on for safe driving. Perform these procedures only if it is necessary to set the buzzer off (disabled).
* When either the battery cable or the combination meter connector is disconnected, these buzzers are set on (enabled).
* The trip odometer returns to 0 after starting this procedure, although it is not displayed.
HINT
"b-OFF" indicates that the buzzer is OFF. "b-on" indicates that the buzzer is ON. The seat belt buzzer ON/OFF setting will be finished (the odometer will display "ODO") if the ODO/TRIP switch is not operated for 10 seconds or more. In this case, perform procedure B to check that the buzzer ON/OFF setting is complete. If it is not complete, start from procedure A again.
(a) Driver and front passenger side seat belt buzzers
(1) Turn the ignition switch ON (Procedure A).
(2) Press the ODO/TRIP switch until the odometer displays "ODO".
(3) Turn the ignition switch off.
(4) Turn the ignition switch ON.
(5) Press the ODO/TRIP switch immediately (within 6 seconds) and hold it down for 10 seconds or more.
(6) Continue holding down the ODO/TRIP switch and fasten the driver side seat belt.
(7) Check that the odometer displays either "b-on" or "b-oFF".
(8) Press the ODO/TRIP switch to change the display to "b-oFF".
(9) Turn the ignition switch off.
(10) Turn the ignition switch ON.
(11) Check that no buzzer sounds when the vehicle speed is 20 km/h (12 mph) or more (Procedure B).
(b) Front passenger side seat belt buzzer
(1) Turn the ignition switch ON (Procedure A).
(2) Press the ODO/TRIP switch until the odometer displays "ODO".
(3) Turn the ignition switch off.
(4) Turn the ignition switch ON.
(5) Sit in the front passenger seat. Press the ODO/TRIP switch immediately (within 6 seconds) and hold it down for 10 seconds or more.
(6) Sit in the front passenger seat. Continue holding down the ODO/TRIP switch and fasten the front passenger side seat belt.
(7) Check that the odometer displays either "b-on" or "b-oFF".
(8) Press the ODO/TRIP switch to change the display to "b-oFF".
(9) Turn the ignition switch off.
(10) Turn the ignition switch ON.
(11) Check that no buzzer sounds when the vehicle speed is 20 km/h (12 mph) or more (Procedure B).