Clutch Start Cancel Switch

CLUTCH: CLUTCH START CANCEL SWITCH: INSPECTION

1. INSPECT CLUTCH START CANCEL SWITCH ASSEMBLY





(a) Using an ohmmeter, check that there is resistance between terminals 2 and 4.

Standard:

10 kOhmsor higher

If the result is not as specified, replace the clutch start cancel switch.

(b) Connect the positive (+) lead from the battery to terminal 3 and connect negative (-) lead to terminal 1.





(c) Using an ohmmeter, check that there is resistance between terminals 2 and 4.

Standard:

10 kOhmsor higher

If the result is not as specified, replace the clutch start cancel switch.

(d) Check that the indicator light comes on and there is resistance between terminals 2 and 4 when the switch is pressed.





Standard:

Blow 1 Ohms

If the result is not as specified, replace the clutch start cancel switch.

(e) Using an ohmmeter, check that there is resistance between terminals 2 and 4 when the battery lead is disconnected.





Standard:

10 kOhmsor higher

If the result is not as specified, replace the clutch start cancel switch.