Removal
A750E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION ASSEMBLY: REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
3. REMOVE NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover)
4. DISCONNECT OXYGEN SENSOR
5. REMOVE EXHAUST PIPE ASSEMBLY
Removal
6. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
7. DRAIN AUTOMATIC TRANSMISSION FLUID
(a) Remove the drain plug and gasket, and drain ATF.
(b) Install a new gasket and drain plug.
Torque : 28 Nm (285 kgf-cm, 21 ft-lbf)
8. REMOVE MANIFOLD STAY
(a) Remove the 3 bolts and manifold stay.
9. REMOVE NO.2 MANIFOLD STAY
(a) Remove the 3 bolts and manifold stay No. 2.
10. DISCONNECT NO.1 OIL COOLER INLET TUBE
(a) Remove the 3 bolts and 2 clamps.
(b) Using a union nut wrench, disconnect the oil cooler inlet tube No. 1.
11. DISCONNECT NO.1 OIL COOLER OUTLET TUBE
(a) Using a union nut wrench, disconnect the oil cooler outlet tube No. 1.
12. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Remove the nut and disconnect the transmission control cable.
(b) Remove the 2 bolts and disconnect the transmission control cable.
13. DISCONNECT CONNECTOR
(a) Disconnect the park/neutral position switch connector.
(b) Disconnect the transmission wire connector.
(c) Disconnect the 2 speed sensor connectors.
14. DISCONNECT WIRE HARNESS
15. REMOVE STARTER ASSEMBLY Removal
16. REMOVE FLYWHEEL HOUSING SIDE COVER
(a) Remove the flywheel housing side cover from the cylinder block.
17. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY
(a) Support the automatic transmission assembly with a transmission jack.
18. REMOVE NO.3 FRAME CROSSMEMBER SUB-ASSEMBLY
(a) Remove the 4 bolts on the frame crossmember sub-assembly No. 3.
(b) Remove the 4 nuts, 4 bolts and frame crossmember sub-assembly No. 3.
19. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
(a) Turn the crankshaft to gain access to each bolt.
(b) Hold the crankshaft pulley nut with a wrench and remove the 6 bolts.
(c) Remove the 9 bolts.
(d) Separate and remove the automatic transmission.
20. REMOVE REAR NO.1 ENGINE MOUNTING INSULATOR
(a) Remove the 4 bolts and engine mounting insulator rear from the automatic transmission.
21. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY