C1310

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: C1310/11: Open or Short in Active Brake Booster Circuit
C1310/11 - Open or Short in Active Brake Booster Circuit

DESCRIPTION

Operates when booster's negative pressure is insufficient and allows for a stable braking control.





WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
When replacing the VSC actuator assembly, perform the zero point calibration Calibration.

HINT
When the brake warning light illuminates, inspect and repair the trouble areas of the brake booster vacuum line first.

PROCEDURE

1. CHECK BRAKE BOOSTER ASSEMBLY

(a) Disconnect the A18 booster connector.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPLACE BRAKE BOOSTER ASSEMBLY Removal
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - ACTIVE BRAKE BOOSTER)

(a) Confirm that the skid control ECU connector and active brake booster connector are properly connected.





(b) Disconnect the A17 ECU connector.

(c) Disconnect the A18 booster connector.

(d) Inspect both the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion.

(e) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE VSC ACTUATOR ASSEMBLY Removal