Operation Check

LIGHTING: LIGHTING SYSTEM: OPERATION CHECK

1. CHECK ILLUMINATED ENTRY SYSTEM OPERATION

(a) The illuminated entry system controls the following lights:

Ignition key cylinder light

Foot light

Map light

Room light

(b) Check the illuminated entry system with the ignition switch OFF.

(1) Check that the lights turn on when unlocking any of the doors that are closed and locked with the ignition switch OFF. Then check that the lights fade out under the following conditions:

Leave the doors unlocked for 15 seconds.

Turn the ignition switch ACC or ON.

Lock all the doors.

(2) Check that the lights stay on for at least 15 seconds after opening any of the doors before fading out. Then check that the lights fade out 15 seconds after closing all the doors.

(c) Check the illuminated entry system with the ignition switch ACC or ON.

(1) Check that the lights stay lit after turning the ignition switch OFF with all the doors closed and the ignition switch ACC or ON. Then check that the lights fade out under the following conditions:

Leave the doors unlocked for 15 seconds.

Turn the ignition switch ACC or ON.

Lock all the doors.

(2) Check that the lights stay on for at least 15 seconds after opening any of the doors. Then check that the lights fade out 15 seconds after closing all the doors.

(3) Check that the lights turn on when opening any of the doors and fade out when closing and locking all the doors or turning the ignition switch ACC or ON.

2. CHECK FOOT LIGHT OPERATION

(a) Check that the lights turn on when unlocking any of the doors that are closed and locked with the ignition switch OFF. Then check that the lights fade out under the following conditions:

Leave the doors unlocked for 15 seconds.

Turn the ignition switch OFF and lock all the doors.

(b) Check that the lights stay on for approximately 15 seconds under the following conditions before going off.

(1) Turn the ignition switch to the ON, and move the shift lever to the P.

(2) Open any of the doors.

(c) Check that the lights dim before going off when the engine is started and the shift lever is moved to any position other than P.

(d) Check the conditions below before the lights turn off.

(1) The lights dim when moving the shift lever into a position other than P and closing all the doors with the engine started.

(2) The lights turn on for approximately 15 seconds and fade out when closing all the doors with the ignition switch OFF and the shift lever in the P position.

(e) Check that the lights turn on after opening any of the doors.

(f) Check that the lights fade out approximately 15 seconds after closing all the doors, or locking all the doors.

(g) Check that the lights turn on gradually with the ignition switch ON and the shift lever in the P position.

(h) Check that the lights dim when shifting the shift lever from P into another position with all the doors closed and the engine started.

(i) Check that the lights stay dimmed with the ignition switch ON and the shift lever in a position other than P.

3. CHECK BATTERY SAVER OPERATION

(a) Turn the ignition switch OFF and close all the doors.

(b) Open the driver side door to turn the room light on, and leave the door open. Check that the light turns off after about 20 minutes.

(c) After the room light turns off, close the driver's door.

(d) Open any door to turn the room light on, and then open another door. Check that the room light turns off within 20 minutes after opening the doors.

4. CHECK LIGHT AUTO TURN OFF OPERATION

(a) Turn the ignition switch ON, and turn the light control switch to TAIL or HEAD.

(b) Turn the ignition switch OFF and open the driver door. If the light control switch is TAIL, check that the taillight turns off immediately. If the light control switch is HEAD, check that the headlight and taillight turn off after approximately 30 seconds.

(c) Turn the ignition switch ON, and turn the light control switch to HEAD.

(d) Turn the ignition switch OFF and open the driver's door. Within 30 seconds, lock all the doors. Check that the headlight and taillight turn off immediately.

5. CHECK DAYTIME RUNNING LIGHT OPERATION

(a) Check that the turn signal lights turn on when the light control switch is OFF with the engine running and the parking brake released. Then check that the lights turn off under the following conditions:

Turn the light control switch to TAIL or HEAD.