Installation

1GR-FE ENGINE CONTROL SYSTEM: POWER STEERING OIL PRESSURE SWITCH: INSTALLATION

1. INSTALL POWER STEERING OIL PRESSURE SENSOR

(a) Install a new O-ring to the oil pressure sensor.

(b) Apply a light coat of engine oil to the O-ring of the oil pressure sensor.

(c) Using a 24 mm deep socket wrench, install the oil pressure sensor.

Torque : 21 Nm (210 kgf-cm, 15 ft-lbf)

NOTICE:
* Do not allow foreign matter to contact the oil seal face of the power steering oil pressure sensor (surface which contacts the pressure feed tube).
* Be careful not to damage the O-ring when installing the power steering oil pressure sensor

(d) Connect the oil pressure sensor connector.

2. ADD POWER STEERING FLUID

3. INSPECT FOR POWER STEERING FLUID LEAK

4. BLEED POWER STEERING FLUID Power Steering System