B1651

SUPPLEMENTAL RESTRAINT SYSTEM: AIRBAG SYSTEM: B1651/33: Manual Cut off Switch Trouble
B1651/33 - Manual Cut off Switch Trouble

DESCRIPTION

The manual cut off switch circuit consists of the center airbag sensor and the airbag cut-off switch cylinder.

The front passenger airbag can be optionally deactivated via this circuit by turning the manual cut-off switch to the OFF position.

If the front passenger airbag is deactivated, the passenger airbag OFF indicator comes on to inform the passengers.

DTC B1651/33 is recorded when a malfunction is detected in the manual cut-off switch circuit.





WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK INSTRUMENT PANEL WIRE





(a) Turn the ignition switch OFF.

(b) Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

(c) Disconnect the connectors from the center airbag sensor and the airbag cut off switch cylinder.

(d) Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

(e) Turn the ignition switch ON.

(f) Measure the voltage according to the value(s) in the table below.

Standard voltage:





(g) Turn the ignition switch OFF.

(h) Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

(i) Using a service wire, connect terminal 14 (MSW+) and 15 (MSW-) of connector B.

(j) Measure the resistance according to the value(s) in the table below.

Standard resistance:





(k) Disconnect the service wire from connector B.

(l) Measure the resistance according to the value(s) in the table below.

Standard resistance:





NG -- REPLACE INSTRUMENT PANEL WIRE
OK -- Continue to next step.

2. INSPECT AIRBAG CUT-OFF SWITCH CYLINDER





(a) Remove the airbag cut-off switch cylinder.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:





NG -- REPLACE AIRBAG CUT-OFF SWITCH CYLINDER Removal
OK -- Continue to next step.

3. CHECK CENTER AIRBAG SENSOR





(a) Connect the connectors to the center airbag sensor and the airbag cut off switch cylinder.

(b) Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

(c) Turn the ignition switch ON, and wait for at least 60 seconds.

(d) Clear the DTCs stored in memory Reading and Clearing Diagnostic Trouble Codes.

(e) Turn the ignition switch OFF.

(f) Turn the ignition switch ON, and wait for at least 60 seconds.

(g) Check the DTCs Reading and Clearing Diagnostic Trouble Codes.

Result





HINT
Codes other than DTC B1651 maybe output at this time, but they are not related to this check.

B -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY Removal

A -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY Removal

C -- USE SIMULATION METHOD TO CHECK Diagnosis System