U0199

CAN COMMUNICATION: CAN COMMUNICATION SYSTEM: U0199: Lost Communication with "Door Control Module A"
U0199 - Lost Communication with "Door Control Module A"

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

HINT
Operating the ignition switch, any other switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

(a) Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NEXT -- Continue to next step.

2. CHECK FOR OPEN IN CAN BUS WIRE (OUTER MIRROR CONTROL ECU BRANCH WIRE)

(a) Disconnect the N8 outer mirror control ECU connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

NG -- REPAIR OR REPLACE OUTER MIRROR CONTROL ECU BRANCH WIRE OR CONNECTOR (CAN, CGND)
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (OUTER MIRROR CONTROL ECU - BATTERY AND BODY GROUND)

(a) Reconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

(b) Disconnect the N7 outer mirror control ECU connector.

(d) Measure the voltage according to the value(s) in the table below.

Standard voltage:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE OUTER MIRROR CONTROL ECU Disassembly