Disassembly

1UR-FE FUEL: FUEL PUMP: DISASSEMBLY

1. REMOVE FUEL SENDER GAUGE ASSEMBLY Removal

2. REMOVE SUB TANK

(a) Disconnect the fuel pump connector.

(b) Using a small screwdriver, detach the claw on the end of the tube from the claw hole. Disconnect the tube from the 2 clamps.

HINT
The O-ring is installed firmly between the jet pump and sub tank. Therefore, the jet pump and sub tank should be removed carefully using a screwdriver that has its tip taped.

(c) Disconnect the fuel tube.

(d) Using a screwdriver, detach the 3 claws from the claw holes.

HINT
Tape the screwdriver tip before use.

(e) Using a screwdriver, detach the 2 claws from the claw holes and remove the sub tank.

HINT
Tape the screwdriver tip before use.

NOTICE:
Do not damage the fuel sub tank.

3. REMOVE FUEL PUMP

(a) Using a screwdriver, detach the 5 claws from the claw holes and disconnect the fuel pump from the suction plate with filter.

HINT
Tape the screwdriver tip before use.

(b) Remove the fuel pump harness.