Transmission Control Switch Circuit

A760E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION SYSTEM: Transmission Control Switch Circuit
- Transmission Control Switch Circuit

DESCRIPTION

After moving the shift lever to S, it is possible to switch the shift range between "1" (S1 range) and "6" (S6 range) using the transmission control switch.

Shifting to "+" once raises the shift range by one, and shifting to "-" once lowers the shift range by one.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. INSPECT TRANSMISSION CONTROL SWITCH

(a) for Column Shift Type:





(1) Disconnect the J25 transmission control switch connector.

(2) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





(b) for Floor Shift Type:





(1) Disconnect the J24 transmission control switch connector.

(2) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





Result





C -- REPLACE TRANSMISSION CONTROL SWITCH (TRANSMISSION FLOOR SHIFT ASSEMBLY) Removal

B -- REPLACE TRANSMISSION CONTROL SWITCH (COLUMN SHIFT SHIFT LEVER SUB-ASSEMBLY) Disassembly
A -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (TRANSMISSION CONTROL SWITCH - BATTERY, BODY GROUND)

(a) for Column Shift Type:





(1) Disconnect the J25 transmission control switch connector.

(2) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





(3) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





(b) for Floor Shift Type:





(1) Disconnect the J24 transmission control switch connector.

(2) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





(3) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (TRANSMISSION CONTROL SWITCH - ECM)

(a) Disconnect the A24 ECM connector.





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





(c) Turn the ignition switch off.

(d) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Symptom Related Diagnostic Procedures