Installation

MIRROR: OUTER REAR VIEW MIRROR: INSTALLATION

HINT
* Use the same procedure for the LH side and RH side.
* The procedure listed below are for the LH side.

1. INSTALL OUTER MIRROR COVER LH (for Extended Type)





(a) Attach the 2 claws to install the cover.

2. INSTALL SIDE TURN SIGNAL LIGHT LENS (for Extended Type)

3. INSTALL OUTER MIRROR COVER (for Standard)





Attach the 3 claws labeled B.

(a) Attach the 4 claws labeled A to install the outer mirror cover.

4. INSTALL OUTER MIRROR LIGHT ASSEMBLY LH (for Standard) Installation

5. INSTALL OUTER REAR VIEW MIRROR SUB-ASSEMBLY Installation

6. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY





(a) Temporarily install the mirror by inserting the claw on the mirror into the holes on the vehicle.

(b) Tighten the 3 nuts in the sequence shown in the illustration and install the mirror.

Torque : 7.8 Nm (80 kgf-cm, 69 in-lbf)

(c) w/ Power Mirror Control System:

Connect the connector labeled A.

7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY Reassembly

8. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH Reassembly

9. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window) Reassembly

10. INSTALL FRONT ARMREST UPPER BASE PANEL (w/ Power Window) Reassembly

11. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG Reassembly