ACIS Control Circuit

3UR-FBE ENGINE CONTROL SYSTEM: SFI SYSTEM: ACIS Control Circuit
- ACIS Control Circuit

DESCRIPTION

This circuit opens and closes the Intake Air Control Valve (IACV) in response to the engine load in order to increase the intake efficiency (ACIS: Acoustic Control Induction System).





WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM (OPERATE VSV FOR ACIS)





(a) Disconnect the vacuum hose from port F on the vacuum switching valve (for ACIS).

(b) Connect the Techstream to the DLC3.

(c) Start the engine.

(d) Enter the following menus: Powertrain / Engine and ECT / Active Test / Active the VSV for Intake Control.

(e) Operate the VSV for ACIS.

(f) Check the VSV air flow when switching the VSV.

OK:





NG -- INSPECT VACUUM SWITCHING VALVE (FOR ACIS)
OK -- Continue to next step.

2. CHECK VACUUM HOSES (VACUUM SWITCHING VALVE - INTAKE AIR CONTROL VALVE, INTAKE MANIFOLD)

NG -- REPAIR OR REPLACE VACUUM HOSES
OK -- Continue to next step.

3. INSPECT INTAKE MANIFOLD (INTAKE AIR CONTROL VALVE)

(a) Inspect the intake air control valve Intake System.

NG -- REPLACE INTAKE MANIFOLD Removal

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Symptom Related Diagnostic Procedures

4. INSPECT VACUUM SWITCHING VALVE (FOR ACIS)

(a) Inspect the vacuum switching valve (for ACIS) Testing and Inspection.

NG -- REPLACE VACUUM SWITCHING VALVE Removal
OK -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR (VACUUM SWITCHING VALVE - ECM AND INTEGRATION RELAY)





(a) Remove the EFI NO. 2 fuse from the engine room relay block.

(b) Check the EFI NO. 2 fuse.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:





(d) Reinstall the EFI NO. 2 fuse.

(e) Disconnect the D62 intake air control valve connector.

(f) Disconnect the D74 ECM connector.

(g) Remove the integration relay from the engine room relay block Component Tests and General Diagnostics.

(h) Disconnect the 1B integration relay connector.

(i) Measure the resistance according to the value(s) in the table below.

Standard resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE ECM Removal