Operation CHARM: Car repair manuals for everyone.

Removal





3UR-FE ENGINE CONTROL SYSTEM: ECM: REMOVAL

1. DISCONNECT CONNECTOR HOLDER BLOCK

(a) Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.





2. REMOVE ECM

(a) Raise the 2 levers while pushing the locks on the 2 levers.





NOTICE:
Make sure that the lock lever is raised 90° as shown in the illustration before disconnecting the connectors. Failure to do this may cause the connectors to break.





(b) Disconnect the 2 connectors.

(c) Remove the 4 bolts and ECM.





3. REMOVE GASKET

(a) Peel off the rubber part of the gasket.





(b) Spray gasket remover or equivalent on the remaining tape of the gasket.





NOTICE:
When using gasket remover or equivalent, cover the ECM connector with a cloth.

(c) Remove the tape of the gasket without using bladed objects.