Safety Connect System

CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: B15C0, B15C1: Short in GPS Antenna
B15C1 - Open in GPS Antenna

DESCRIPTION

This DTC is stored when the DCM (Telematics Transceiver) detects an open or a short in the telephone and GPS antenna circuit. The DCM (Telematics Transceiver) receives signals at a radio frequency of between 1574.42 and 1576.42 MHz through the telephone and GPS antenna. The cable is a 50 Ohms coaxial cable.





HINT
Refer to "Parts Location" for installation location of the telephone and GPS antenna cord Locations.

INSPECTION PROCEDURE

PROCEDURE

1. CHECK FOR DTC

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON and wait for 10 seconds.

(d) Perform "Health Check" and check for current DTCs Health Check.

Result





B -- CHECK FOR INTERMITTENT PROBLEMS How To Proceed With Troubleshooting
A -- Continue to next step.

2. INSPECT TELEPHONE AND GPS ANTENNA CORD (NO. 3 ANTENNA CORD SUB-ASSEMBLY)

(a) Disconnect the No. 3 antenna cord sub-assembly from the telephone antenna assembly connector.





(b) Disconnect the No. 3 antenna cord sub-assembly from the No. 2 antenna cord sub-assembly.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPLACE TELEPHONE AND GPS ANTENNA CORD (NO. 3 ANTENNA CORD SUB-ASSEMBLY) Removal
OK -- Continue to next step.

3. INSPECT TELEPHONE AND GPS ANTENNA CORD (NO. 2 ANTENNA CORD SUB-ASSEMBLY)

(a) Disconnect the No. 2 antenna cord sub-assembly from the No. 3 antenna cord sub-assembly.





(b) Disconnect the No. 2 antenna cord sub-assembly from the antenna cord sub-assembly.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPLACE TELEPHONE AND GPS ANTENNA CORD (NO. 2 ANTENNA CORD SUB-ASSEMBLY) Removal
OK -- Continue to next step.

4. INSPECT TELEPHONE AND GPS ANTENNA CORD (INSTRUMENT PANEL WIRE)

(a) Disconnect the antenna cord sub-assembly from the No. 2 antenna cord sub-assembly.





(b) Disconnect the antenna cord sub-assembly from the antenna cord sub-assembly.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPLACE TELEPHONE AND GPS ANTENNA CORD (INSTRUMENT PANEL WIRE)
OK -- Continue to next step.

5. REPLACE TELEPHONE AND GPS ANTENNA (TELEPHONE ANTENNA ASSEMBLY)

(a) Replace the telephone antenna assembly with a normally functioning one and check if the same problem occurs again Removal.

OK:

The system returns to normal.

NG -- REPLACE DCM (TELEMATICS TRANSCEIVER)

OK -- END (TELEPHONE AND GPS ANTENNA IS DEFECTIVE)

6. REPLACE DCM (TELEMATICS TRANSCEIVER)

(a) Replace the DCM (Telematics Transceiver) Removal.

NOTICE:
* The ignition switch must be off.
* Do not replace the DCM (Telematics Transceiver) with one from another vehicle.

NEXT -- PERFORM DCM ACTIVATION DCM Activation