How To Proceed With Troubleshooting

EXTERIOR PANELS / TRIM: AUTOMATIC RUNNING BOARD SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING

HINT
Use these procedures to troubleshoot the automatic running board system.

1. VEHICLE BROUGHT TO WORKSHOP

NEXT -- Continue to next step.

2. INSPECT BATTERY VOLTAGE

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

NEXT -- Continue to next step.

3. CHECK FOR DTC

(a) Check for DTCs and make a note of any codes that are output.

Result





B -- GO TO DIAGNOSTIC TROUBLE CODE CHART Automatic Running Board System
A -- Continue to next step.

4. PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table Symptom Related Diagnostic Procedures.

Result





B -- GO TO STEP 6
A -- Continue to next step.

5. OVERALL ANALYSIS AND TROUBLESHOOTING

(a) Operation Check Operation Check.

(b) Terminals of ECU Pinout Values and Diagnostic Parameters.

NEXT -- Continue to next step.

6. REPAIR OR REPLACE

NEXT -- Continue to next step.

7. CONFIRMATION TEST

NEXT -- END