Headlight (Hi-Beam) Circuit

LIGHTING (EXT): LIGHTING SYSTEM: Headlight (HI-BEAM) Circuit
- Headlight (HI-BEAM) Circuit

DESCRIPTION

The main body ECU receives headlight dimmer switch information signals, and illuminates the high beam headlight.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM (HEADLIGHT DIMMER RELAY)

(a) Using the Techstream, perform the Active Test Exterior Lighting System.

Main Body





OK:

Relay operates (high beam headlights illuminate).

NG -- INSPECT HEADLIGHT DIMMER RELAY (H-LP HI)

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Exterior Lighting System

2. INSPECT HEADLIGHT DIMMER RELAY (H-LP HI)

(a) Remove the headlight dimmer relay from the engine room relay block, junction block.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPLACE HEADLIGHT DIMMER RELAY
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (BATTERY - HEADLIGHT DIMMER RELAY [H-LP HI])

(a) Measure the voltage according to the value(s) in the table below.





Standard Voltage:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

4. CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER RELAY [H-LP HI] - MAIN BODY ECU)

(a) Remove the main body ECU Removal.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Exterior Lighting System