Installation

EXTERIOR PANELS / TRIM: AUTOMATIC RUNNING BOARD: INSTALLATION

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. INSTALL POWER LIFT STEP ASSEMBLY

(a) Install the power lift step assembly with the 2 nuts and 4 bolts.

Torque : 16 Nm (163 kgf-cm, 12 ft-lbf)

(b) Connect the connector.

2. INSTALL STEP PLATE

(a) Open the door and deploy the side auto step fully.

(b) Using a 5 mm hexagon wrench, install the step plate with the 4 hexagon bolts.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

HINT
After replacing the power lift step assembly with a new one, install the step plate, and then cut off the clamp with the power lift step assembly extended.





Text in Illustration





3. REMOVE ROCKER PANEL MOULDING (for X-Runner)