Operation Check

METER / GAUGE / DISPLAY: METER / GAUGE SYSTEM: OPERATION CHECK

1. INSPECT INDICATOR/WARNING LIGHT

(a) Check the following indicators and warning lights.





* *1: for U.S.A.

* *2: except U.S.A.

* *3: for 4WD

* *4: w/ CRAWL Control

* *5: for 2WD

* *6: w/ Kinetic Dynamic Suspension System

* *7: w/ Tire Pressure Warning System

* *8: w/ Level Warning Switch Assembly

2. INSPECT SPEEDOMETER

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Powertrain / Engine and ECT / Data List.

(e) According to the display on Techstream, read the Data List.

Reference:

mph (for U.S.A.)





km/h (except U.S.A.)





If the result is not as specified, the speedometer may have a malfunction.

NOTICE:
Do not use worn, underinflated or overinflated tires, as the speedometer reading will be inaccurate.

(f) Check the deflection width of the speedometer indicator.

Reference:

Within 0.3°

3. INSPECT TACHOMETER

(a) Connect the Techstream and start the engine.

(b) Compare the test results with the tachometer indicator.

DC 13.5 V, at 25°C (77°F):





If the result is not as specified, the tachometer may have a malfunction.

4. INSPECT METER/GAUGE

(a) Connect the Techstream to the DLC3.

(b) Perform the Active Test Meter / Gauge System.

OK:

Each meter/gauge needle indication is normal.

5. INSPECT WARNING/INDICATOR LIGHT

(a) Connect the Techstream to the DLC3.

(b) Perform the Active Test Meter / Gauge System.

OK:

Each warning/indicator light can be turned on and off using the Techstream.

6. INSPECT MULTI-INFORMATION DISPLAY (for Optitron Meter)

(a) Connect the Techstream to the DLC3.





(b) Perform the Active Test Meter / Gauge System.

HINT
If this Active Test is being performed and the ignition switch is turned off and then to ON, the clock and ODO/TRIP display background may turn white. If this occurs, end the Active Test and turn the ignition switch off.

OK:

All dots in the multi-information display can be turned on and off using the Techstream.

7. INSPECT MULTI-INFORMATION DISPLAY (for Analog Meter)

(a) Connect the Techstream to the DLC3.





(b) Perform the Active Test Meter / Gauge System.

HINT
If this Active Test is being performed and the ignition switch is turned off and then to ON, the clock and ODO/TRIP display background may turn white. If this occurs, end the Active Test and turn the ignition switch off.

OK:

All dots in the multi-information display can be turned on and off using the Techstream.