Installation

VF2A TRANSFER / 4WD / AWD: 4WD CONTROL ECU: INSTALLATION

1. INSTALL 4 WHEEL DRIVE CONTROL ECU NO.2

(a) Install the four wheel drive control ECU with the bolt.

Torque : 13 Nm (127 kgf-cm, 9 ft-lbf)

(b) Connect the 2 connectors.

2. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation

3. INSTALL INSTRUMENT PANEL BOX DOOR COVER Installation

4. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY Installation

5. REMOVE LOWER INSTRUMENT COVER LH Installation

6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

7. INSTALL COWL SIDE TRIM BOARD RH Installation

8. INSTALL DOOR SCUFF PLATE ASSEMBLY RH Installation

9. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation