Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: STEERING ANGLE SENSOR: INSTALLATION

1. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR

(a) Install the spiral cable with steering angle sensor Installation.

NOTICE:
* Do not replace the spiral cable with the battery connected and the ignition switch ON.
* Do not rotate the spiral cable with the battery connected and the ignition switch ON.
* Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
* Do not remove the steering angle sensor from the spiral cable.

2. INSTALL UPPER STEERING COLUMN COVER Installation

3. INSTALL LOWER STEERING COLUMN COVER Installation

4. ADJUST SPIRAL CABLE Installation

5. INSTALL STEERING WHEEL ASSEMBLY

(a) Install the steering wheel assembly Installation.

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

7. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light System Description.