Rear View Monitor System (w/ Navigation System)

PARK ASSIST / MONITORING: REAR VIEW MONITOR SYSTEM (w/ Navigation System): HOW TO PROCEED WITH TROUBLESHOOTING

HINT
Use the following procedure to troubleshoot the rear view monitor system.

1. VEHICLE BROUGHT TO WORKSHOP

NEXT -- Continue to next step.

2. CUSTOMER PROBLEM ANALYSIS

NEXT -- Continue to next step.

3. INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage with the ignition switch off.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

NEXT -- Continue to next step.

4. PROBLEM SYMPTOM CONFIRMATION

Result:





B -- Go to step 6
A -- Continue to next step.

5. SYMPTOM SIMULATION

NEXT -- Continue to next step.

6. CHECK DTC FOR NAVIGATION SYSTEM

(a) Check for Navigation System DTCs Reading and Clearing Diagnostic Trouble Codes.

Result:





B -- GO TO DIAGNOSTIC TROUBLE CODE CHART FOR NAVIGATION SYSTEM Navigation System
A -- Continue to next step.

7. CHECK IF SAME SYMPTOM APPEARS IN NAVIGATION SYSTEM

(a) Refer to the Navigation System Problem Symptoms Table.

Result:





B -- GO TO NAVIGATION SYSTEM (FOLLOW THE NAVIGATION SYMPTOM CHART TO PERFORM TROUBLESHOOTING)
A -- Continue to next step.

8. PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table Rear View Monitor System (w/ Navigation System).

Result:





B -- Go to step 10
A -- Continue to next step.

9. PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM

(a) Refer to Terminals of ECU Rear View Monitor System (w/ Navigation System).

NEXT -- Continue to next step.

10. ADJUST, REPAIR OR REPLACE

NEXT -- Continue to next step.

11. CONFIRMATION TEST

NEXT -- END