Voice is Not Recognized

NAVIGATION: NAVIGATION SYSTEM: Voice is not Recognized
- Voice is not Recognized

INSPECTION PROCEDURE

PROCEDURE

1. CHECK NAVIGATION SETTING

(a) Display the "Voice Settings" screen.

(b) Check that "Voice Recognition Guidance" is not "Off".





OK:

"Voice Recognition Guidance" is not "Off".

Text in Illustration





NG -- TURN VOICE RECOGNITION GUIDANCE "On"
OK -- Continue to next step.

2. CHECK MAP DISC

(a) Check that the map disc is not deformed or cracked.





OK:

No deformations or cracks on the map disc

NG -- REPLACE MAP DISC
OK -- Continue to next step.

3. CHECK MAP DISC

(a) Check for dirt on the map disc surface.





OK:

No dirt is on the map disc surface.

NOTICE:
Do not use a conventional record cleaner or anti-static preservative.

HINT
If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.

NG -- CLEAN MAP DISC
OK -- Continue to next step.

4. CHECK MICROPHONE (OPERATION CHECK)

(a) Enter the "Microphone & Voice Recognition Check" screen. Refer to Check Mic & Voice Recognition in Operation Check Operation Check.





(b) When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

(c) Push the recording switch and perform voice recording.

HINT
* Select the recording switch with the blower motor of the air conditioning system stopped. If an outlet of the air conditioning system is facing the microphone, noise may be recorded.
* Voice can be recorded up to 5 seconds.

(d) Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

OK:

All check results are normal.

Text in Illustration





NG -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Problem Symptoms Table

OK -- REPLACE NAVIGATION RECEIVER ASSEMBLY Removal