Installation

SUSPENSION: FRONT SUSPENSION MEMBER: INSTALLATION

1. INSTALL FRONT SUSPENSION MEMBER BODY MOUNTING REAR CUSHION LH

(a) Temporarily install a new front suspension member body mounting rear cushion LH while confirming the installation direction.





NOTICE:
Position the front suspension member body mounting rear cushion in the correct direction.

(b) Install SST as shown in the illustration.





SST : 09830-10010

09830-01010

09830-01020

09830-01030

09830-01060

(c) Using SST, install the front suspension member body mounting rear cushion LH as shown in the illustration.





NOTICE:
Check that there is no clearance between the front suspension member and the front suspension member body mounting rear cushion LH.

2. INSTALL FRONT SUSPENSION MEMBER BODY MOUNTING REAR CUSHION RH

(a) Temporarily install a new front suspension member body mounting rear cushion RH while confirming the installation direction.





NOTICE:
Position the front suspension member body mounting rear cushion in the correct direction.

(b) Using SST, install the front suspension member body mounting rear cushion RH.

SST : 09830-10010

09830-01010

09830-01020

09830-01030

09830-01060

HINT
Perform the same procedure as the LH side.

3. INSTALL FRONT SUSPENSION MEMBER BODY MOUNTING FRONT CUSHION

(a) Temporarily install a new front suspension member body mounting front cushion while confirming the installation direction.





NOTICE:
Position the front suspension member body mounting front cushion in the correct direction.

(b) Using SST, install the front suspension member body mounting front cushion as shown in the illustration.





SST : 09830-10010

09830-01010

09830-01020

09830-01030

09830-01060

NOTICE:
Check that there is no clearance between the front suspension member and the front suspension member body mounting rear cushion.

4. INSTALL FRONT SUSPENSION MEMBER BODY MOUNTING REAR STOPPER

5. INSTALL FRONT SUSPENSION MEMBER BODY MOUNTING FRONT STOPPER

6. INSTALL FRONT SUSPENSION MEMBER DYNAMIC DAMPER

(a) Install the front suspension member dynamic damper with the 2 bolts.





Torque : 29 Nm (296 kgf-cm, 21 ft-lbf)

7. INSTALL FRONT LOWER SUSPENSION ARM LH Installation

8. INSTALL FRONT LOWER SUSPENSION ARM RH

HINT
Perform the same procedure as the LH side.

9. INSTALL TRANSVERSE ENGINE MOUNTING INSULATOR (for 2GR-FE) Installation

10. INSTALL FRONT FRAME ASSEMBLY (for 2GR-FE) Installation

11. INSTALL FRONT FRAME ASSEMBLY (for 1AR-FE) Installation

12. REMOVE ENGINE HANGERS (for 2GR-FE) Installation

13. REMOVE ENGINE HANGER NO.1 (for 1AR-FE)

14. INSTALL POWER STEERING LINK ASSEMBLY Installation

15. INSTALL FRONT STABILIZER BAR WITH FRONT STABILIZER LINK ASSEMBLY

16. INSTALL NO. 1 FRONT STABILIZER BRACKET LH Installation

17. INSTALL NO. 1 FRONT STABILIZER BRACKET RH

HINT
Perform the same procedure as the LH side.

18. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

HINT
* Refer to the procedure from Install Engine Assembly with Transaxle (for 2GR-FE) Installation.
* Refer to the procedure from Install Engine Assembly with Transaxle (for 1AR-FE) Installation.