Initial Inspection and Diagnostic Overview

AUDIO / VISUAL: REAR SEAT ENTERTAINMENT SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING

HINT
Use the following procedure to troubleshoot the rear seat entertainment system.

1. VEHICLE BROUGHT TO WORKSHOP

NEXT -- Continue to next step.

2. INSPECT BATTERY VOLTAGE

(a) Inspect the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

NEXT -- Continue to next step.

3. CHECK FOR DTC

(a) Refer to the DTC Check / Clear Reading and Clearing Diagnostic Trouble Codes.

Result:





HINT
If the system cannot enter diagnostic mode, inspect the AVC-LAN and all the components that are connected to the AVC-LAN for short circuits and repair or replace the malfunctioning part AVC-LAN Circuit.

B -- GO TO STEP 7
A -- Continue to next step.

4. DTC CLEAR

(a) Clear the DTCs and finish diagnostic mode.

HINT
The current DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.

NEXT -- Continue to next step.

5. RECHECK FOR DTC

(a) Recheck for DTCs.

Result:





HINT
* If the system cannot enter diagnostic mode, inspect the AVC-LAN and all the components that are connected to the AVC-LAN for short circuits.
* Even if the malfunction symptom is not confirmed, check for diagnostic trouble codes. This is because the system stores history diagnostic trouble codes.
* Refer to the detailed description on the diagnostic screen as necessary System Description.
* Check the diagnostic trouble code and inspect the area that the code indicates.

B -- GO TO STEP 7
A -- Continue to next step.

6. DIAGNOSTIC TROUBLE CODE CHART

(a) Find the output code in the diagnostic trouble code chart Rear Seat Entertainment System.

NEXT -- GO TO STEP 9

7. PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table Problem Symptoms Table.

Result:





HINT
If the symptom does not recur and no DTC is output, perform the symptom simulation method How To Proceed With Troubleshooting.

B -- GO TO STEP 9
A -- Continue to next step.

8. PERFORM TROUBLESHOOTING BASED ON THE MALFUNCTION SYMPTOM

(a) Refer to Terminals of ECU Pinout Values and Diagnostic Parameters.

NEXT -- Continue to next step.

9. CHECK SUSPECTED AREAS

(a) Adjust, repair or replace as necessary.

NEXT -- Continue to next step.

10. RECHECK FOR DTC

HINT
After clearing the DTCs, recheck for DTCs.

NEXT -- Continue to next step.

11. PERFORM CONFIRMATION TEST

NEXT -- END