Parking Brake Switch Circuit

NAVIGATION: NAVIGATION SYSTEM: Parking Brake Switch Circuit
- Parking Brake Switch Circuit

DESCRIPTION

This circuit is from the parking brake switch assembly to the navigation receiver assembly.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK BRAKE WARNING LIGHT

(a) Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.

OK:

The brake warning light operates as specified above.

NG -- INSPECT PARKING BRAKE SWITCH ASSEMBLY
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - NAVIGATION RECEIVER ASSEMBLY)

(a) Disconnect the E5 navigation receiver assembly connector.

(b) Disconnect the A17 parking brake switch assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Problem Symptoms Table

3. INSPECT PARKING BRAKE SWITCH ASSEMBLY

(a) Disconnect the A17 parking brake switch assembly connector.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPLACE PARKING BRAKE SWITCH ASSEMBLY

OK -- REPAIR OR REPLACE HARNESS OR CONNECTOR