Sound Signal Circuit Between Navigation Receiver Assembly and Multi-media Interface ECU
NAVIGATION: NAVIGATION SYSTEM: Sound Signal Circuit between Navigation Receiver Assembly and Multi-media Interface ECU
- Sound Signal Circuit between Navigation Receiver Assembly and Multi-media Interface ECU
DESCRIPTION
The multi-media interface ECU sends USB audio sound signals or satellite radio sound or RSE sound*1 signals to the navigation receiver assembly via the sound signal circuit.
The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the television display assembly*1, stereo component amplifier assembly, navigation receiver assembly or speakers.
* *1: w/ Rear Seat Entertainment System
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - MULTI-MEDIA INTERFACE ECU)
(a) Disconnect the E15 navigation receiver assembly connector.
(b) Disconnect the E30 multi-media interface ECU connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Problem Symptoms Table