Installation

U151F AUTOMATIC TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Install the park/neutral position switch to the manual valve shaft.





(b) Temporarily install the 2 bolts.

(c) Place a new lock plate and tighten the nut.





Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)

(d) Temporarily install the control shaft lever.

(e) Turn the lever counterclockwise until it stops and then turn it clockwise 2 notches.





(f) Remove the control shaft lever.

(g) Align the groove with the neutral basic line.





(h) Hold the switch in position and tighten the 2 bolts.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(i) Using a screwdriver, bend the tabs of the lock plate.





(j) Install the control shaft lever washer and nut.





Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)

(k) Connect the park/neutral position switch connector.





2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Connect the control cable to the control shaft lever with the nut.





Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

(b) Install the control cable to the bracket with a new clip.





3. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY Adjustments

4. ADJUST SHIFT LEVER POSITION Adjustments

5. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION Initial Inspection and Diagnostic Overview

6. INSPECT SHIFT LEVER POSITION Initial Inspection and Diagnostic Overview

7. INSTALL AIR CLEANER BRACKET Installation

8. INSTALL AIR CLEANER CASE SUB-ASSEMBLY Installation

9. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

10. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation

11. INSTALL NO. 1 AIR CLEANER INLET Installation

12. INSTALL NO. 2 AIR CLEANER INLET Installation

13. INSTALL COOL AIR INTAKE DUCT SEAL Installation

14. INSTALL BATTERY Installation

15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.