Installation

2GR-FE FUEL: FUEL INJECTOR: INSTALLATION

1. INSTALL FUEL INJECTOR ASSEMBLY

(a) Apply a light coat of spindle oil or gasoline to new O-rings, and install them to each injector.

NOTICE:
The wound or the foreign body must not adhere in the ditch of O-ring.





(b) Apply a light coat of spindle oil or gasoline where the fuel delivery pipe contacts the O-ring.





(c) Push the fuel injector while turning it to install the injector in the fuel delivery pipe.

(d) Position the fuel injector connector outward.

NOTICE:
* Be careful not to twist the O-ring.
* After installing the fuel injector, check that it turns smoothly. If not, reinstall it with a new O-ring.

2. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY Installation

3. CONNECT FUEL TUBE SUB-ASSEMBLY Installation

4. TEMPORARILY INSTALL NO. 1 SURGE TANK STAY Installation

5. TEMPORARILY INSTALL THROTTLE BODY BRACKET Installation

6. INSTALL INTAKE AIR SURGE TANK ASSEMBLY Installation

7. FULLY TIGHTEN NO. 1 SURGE TANK STAY Installation

8. FULLY TIGHTEN THROTTLE BODY BRACKET Installation

9. CONNECT ENGINE ROOM MAIN WIRE Installation

10. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL Installation

12. INSPECT SRS WARNING LIGHT Installation

13. INSPECT FOR FUEL LEAK Fuel System

14. ADD ENGINE COOLANT Service and Repair

15. INSPECT FOR ENGINE COOLANT LEAK Testing and Inspection

16. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

17. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY Installation

18. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY Installation

19. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation

20. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation

21. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation

22. INSTALL NO. 1 ENGINE UNDER COVER Installation

23. INSTALL ENGINE UNDER COVER ASSEMBLY Installation