Body - Windshield Dam/Weatherstrip is Loose/Visible

T-SB-0040-13

March 7, 2013

Windshield Dam Is Loose/Visible

Service Category
Vehicle Exterior

Section
Window/Glass

Market
USA





Applicability

Introduction

Some 2010 - 2013 model year Tundra vehicles may exhibit a condition where a deformed windshield dam or some weatherstrip may be loose between the A-pillar garnish and windshield glass. Normally the windshield dam is not visible and is only necessary for production. Over time the dam adhesive may lose adhesion and deform. There is no functional concern with the windshield sealing and there is no need to replace or reseal the windshield if there are no complaints of water/air leaks. Please follow the process below to remove the exposed portion of the windshield dam.

Production Change Information








This bulletin applies to vehicles produced BEFORE the Production Change Effective VINs shown.





Warranty Information





1. Confirm that the windshield dam is loose.

2. Remove the front pillar garnish.

A. Using a screwdriver detach the 2 claws and remove the 2 assist grip plugs.

B. Remove the 2 bolts and assist grip.

C. Detach the claw and remove the front pillar garnish.





3. Using scissors or a utility knife cut along the dashed lines shown in Figure 3. Once cut discard the center section that was removed and tuck the loose ends back into their corresponding locations.

4. Reassemble vehicle in reverse order.

5. Verify that the windshield dam is no longer visible from inside the cabin or from the outside looking in.

© 2013 Toyota Motor Sales, USA