(Right), Components

NOTE:
- Depending on equipment installed, remove seats and/or seat benches See 'Body And Frame, Seats.' Service and Repair , for storage area See 'Accessory Compartment.'
- To remove rear side panel molded trim, remove rear headliner trim, left upper B-pillar trim, left C-pillar trim, D-pillar trim, loosen rear edge cover on both sides. See 'Body And Frame, Interior Trim.'






1 - Gasket
- Ensure correct positioning of rear side panel molded trim.
2 - Clip
- Two-piece
- Insert sleeve in C-pillar hole, install pin in trim.
3 - Spring clamp
4 - Rear side panel molded trim
- Removing/Installing See 'Trim Panel.' Service and Repair
5 - Clip
- On back
- Several located along window edge.
6 - Clip
- Two-piece
- Removing: Remove inner part with Allen wrench
- Installing: Press outer part and inner pan into hole simultaneously
7 - Trim plug
8 - Guide cover
9 - Phillips screw
10 - Cover
11 - Plug
12 - Phillips screw
13 - Belt guide with closure strip
14 - Cap
15 - Hex bolt
- 40 Nm (30 ft lb)
16 - Spacer
17 - Phillips screw
- With washer and cap